SSA (sage system administration) should NOT require admin access on the local machine
SSA (sage system administration) should NOT require admin access on the local machine as stated in the subject; the admin tool is installed using a "click-once"nstaller and so it installs against the users profile (and thus does not require admin ...
Guest
over 2 years ago
in Installation
0
Idea Accepted - Gauging Support
Allow separate default nominal codes for Bad Debt and Bad Debt Provision
At the moment the system only has on nominal code for writing off the bad debt or bad debt provision.
It would be better if there were separate default nominal codes for these.
Click once seems a good idea however it is leading to longer installs & in the case of users using terminal services excessive disk space being used, i.e. Sage 200 occupies ~250MB for the client, if you have a terminal services site you end up...
Guest
about 8 years ago
in Installation
0
Idea Accepted - Gauging Support
Default Nominal Accounts. Allow quot;Use Specifiedquot; for any default
Allow the option of nbsp;quot;Use Specifiedquot; for any of the default nominal codes, particularly in the Pamp;L section. This would allow Exchange Differences for examplenbsp;to be posted to an account with a Cost Centre / Dept but not the one s...
For foreign currency customer accounts when you allocate a receipt to an invoice the automatic posting for exchange differences always adopts the default cost centre and department on the customer account. Potentially this means you have to set up...
Additional Control Ledger Nominal Accounts for Sales/Purchase Ledger.
Addition to default Debtor / Creditor control Nominal Account, some customers have asked to allow them to assign a separate NL Control Account at Supplier / Customer account level. By default Customer/Purchase Account will have default debtor/cred...
Sage 200 Client - Restrict session permission to one session
It's currently possible for the same user to run the sage client application more than once - this takes up additional user licences and can also cause other issues
Saeed Malik
almost 6 years ago
in Installation
1
Idea Accepted - Gauging Support
Default Nominal Accounts - Ignore Cost Centre and Departments
[ASM-System-System Settings] allows you to set &Split postings between cost centres for Balance Sheet accounts& And then further controlled in [Nominal-Utilities-Ledger Setup-Default Nominal Accounts] for Creditors& and Debtors& Co...
I had a journal stuck in the deferred transaction list as the account code did not exist i.e. cost centre and department code did not exist in the combination used. I set-up the account code and then went to correct the journal in the list, but it...
