Ability to adjust decimal places to 2 on currency should be allowed as it can throw out the final invoice figure but we are in a country that has only 2 decimal places so it is unrealistic to have more than one on item prices. Figure should be rou...
Christine Sellick
about 2 years ago
in Decimal Precision
1
Idea Accepted - Gauging Support
Allow separate default nominal codes for Bad Debt and Bad Debt Provision
At the moment the system only has on nominal code for writing off the bad debt or bad debt provision.
It would be better if there were separate default nominal codes for these.
Would it be possible to add a setting to restrict the number of decimal places in Sage 200 to 2 decimal places
Would it be possible to add a setting to restrict the number of decimal places in Sage 200 to 2 decimal places? This would prevent rounding issues and make it easier for accounting (ie. stock item set up at say £1.54456 could cause rounding issues...
Guest
almost 11 years ago
in Decimal Precision
0
Idea Accepted - Gauging Support
Make Decimal Places on Screens flexible - eg Sales Orders, Purchase Orders, Stock Control
Many customers do not use Decimal places to 5 decimal places and this causes user errors. There needs to a setting in each module to set the decimal places on screens. Option need to be between 0 & 5 decimal places
Saeed Malik
almost 9 years ago
in Decimal Precision
0
Idea Accepted - Gauging Support
Default Nominal Accounts. Allow quot;Use Specifiedquot; for any default
Allow the option of nbsp;quot;Use Specifiedquot; for any of the default nominal codes, particularly in the Pamp;L section. This would allow Exchange Differences for examplenbsp;to be posted to an account with a Cost Centre / Dept but not the one s...
For foreign currency customer accounts when you allocate a receipt to an invoice the automatic posting for exchange differences always adopts the default cost centre and department on the customer account. Potentially this means you have to set up...
Additional Control Ledger Nominal Accounts for Sales/Purchase Ledger.
Addition to default Debtor / Creditor control Nominal Account, some customers have asked to allow them to assign a separate NL Control Account at Supplier / Customer account level. By default Customer/Purchase Account will have default debtor/cred...
Default Nominal Accounts - Ignore Cost Centre and Departments
[ASM-System-System Settings] allows you to set &Split postings between cost centres for Balance Sheet accounts& And then further controlled in [Nominal-Utilities-Ledger Setup-Default Nominal Accounts] for Creditors& and Debtors& Co...
I had a journal stuck in the deferred transaction list as the account code did not exist i.e. cost centre and department code did not exist in the combination used. I set-up the account code and then went to correct the journal in the list, but it...
