Option to delete unused VAT Code/Tax code configured by mistake.
We had a support call yesterday from a customer who had created a new VAT code and immediately realised they shouldn't have done so. They had already amended the description to "DO NOT USE" before calling us to see if we could delete the code. We ...
Ed Loach
8 months ago
in VAT Rates
0
Idea Accepted - Gauging Support
Allow separate default nominal codes for Bad Debt and Bad Debt Provision
At the moment the system only has on nominal code for writing off the bad debt or bad debt provision.
It would be better if there were separate default nominal codes for these.
Default Nominal Accounts. Allow quot;Use Specifiedquot; for any default
Allow the option of nbsp;quot;Use Specifiedquot; for any of the default nominal codes, particularly in the Pamp;L section. This would allow Exchange Differences for examplenbsp;to be posted to an account with a Cost Centre / Dept but not the one s...
For foreign currency customer accounts when you allocate a receipt to an invoice the automatic posting for exchange differences always adopts the default cost centre and department on the customer account. Potentially this means you have to set up...
Hi, Would it be possible to increase the number of VAT codes available. I understand currently that you can have up to T99 available but it is not possible to have 3 digits i.e. 100-999. For those with complex VAT situations this would be extremel...
Guest
about 6 years ago
in VAT Rates
0
Idea Accepted - Gauging Support
Additional Control Ledger Nominal Accounts for Sales/Purchase Ledger.
Addition to default Debtor / Creditor control Nominal Account, some customers have asked to allow them to assign a separate NL Control Account at Supplier / Customer account level. By default Customer/Purchase Account will have default debtor/cred...
Wasn't sure where to put this but thought here was as good as any. Why doesn't Sage software have the same VAT rates? For example: Sage50 T0 = Zero Rated T2 = Exempt T5 = Lower Rate People migrate to Sage 200 and the default is: 0 = Exempt 2 = Zer...
David Shearer
over 2 years ago
in VAT Rates
0
Idea Accepted - Gauging Support
Default Nominal Accounts/Tax Rates - Nominal Codes/Exchange Rate Table - Nominal Codes - users to have the ability to store CC and Dept
One of the top customer requests for many years from sites that use foreign currency - currently you cannot specify cost centre/depts. in the nominal defaults/tax codes and exchange rate settings. two aspects - 1/ a journal has to be posted to the...
Saeed Malik
over 8 years ago
in VAT Rates
0
Idea Accepted - Gauging Support
Default Nominal Accounts - Ignore Cost Centre and Departments
[ASM-System-System Settings] allows you to set &Split postings between cost centres for Balance Sheet accounts& And then further controlled in [Nominal-Utilities-Ledger Setup-Default Nominal Accounts] for Creditors& and Debtors& Co...
I had a journal stuck in the deferred transaction list as the account code did not exist i.e. cost centre and department code did not exist in the combination used. I set-up the account code and then went to correct the journal in the list, but it...
