Allow separate default nominal codes for Bad Debt and Bad Debt Provision
At the moment the system only has on nominal code for writing off the bad debt or bad debt provision.
It would be better if there were separate default nominal codes for these.
Similar to debtor letters but have the overdue invoices attached.
To be able to run a report that automatically sends out overdue invoices to clients and the reminder text in the email not attached as pdf as debtor letters does, as I have found when sending the debtor letters clients then reply and request the i...
Guest
about 9 years ago
in Letters
1
Idea Accepted - Gauging Support
Default Nominal Accounts. Allow quot;Use Specifiedquot; for any default
Allow the option of nbsp;quot;Use Specifiedquot; for any of the default nominal codes, particularly in the Pamp;L section. This would allow Exchange Differences for examplenbsp;to be posted to an account with a Cost Centre / Dept but not the one s...
Generate custom letters to all suppliers and/or customers
It would be helpful if Sage 200 had the facility to produce one-off custom letters to be sent to suppliers and or customers, e.g. to notify a change of email address. I am told by support that such a facility is not available.
Guest
over 7 years ago
in Letters
0
Idea Accepted - Gauging Support
For foreign currency customer accounts when you allocate a receipt to an invoice the automatic posting for exchange differences always adopts the default cost centre and department on the customer account. Potentially this means you have to set up...
Additional Control Ledger Nominal Accounts for Sales/Purchase Ledger.
Addition to default Debtor / Creditor control Nominal Account, some customers have asked to allow them to assign a separate NL Control Account at Supplier / Customer account level. By default Customer/Purchase Account will have default debtor/cred...
Default Nominal Accounts - Ignore Cost Centre and Departments
[ASM-System-System Settings] allows you to set &Split postings between cost centres for Balance Sheet accounts& And then further controlled in [Nominal-Utilities-Ledger Setup-Default Nominal Accounts] for Creditors& and Debtors& Co...
I had a journal stuck in the deferred transaction list as the account code did not exist i.e. cost centre and department code did not exist in the combination used. I set-up the account code and then went to correct the journal in the list, but it...
