Sage 200 UKI Ideas Portal

Please note the following Sage 200 Ideas Portal Guidelines apply to the use of this portal.

ADD A NEW IDEA

Clear

Ideas

    Showing 8

    Allow separate default nominal codes for Bad Debt and Bad Debt Provision

    At the moment the system only has on nominal code for writing off the bad debt or bad debt provision. It would be better if there were separate default nominal codes for these.
    Sarah Lancaster about 2 years ago in Default Nominal Accounts 0 Idea Accepted - Gauging Support

    Write Off Small amounts to follow Transaction Date Validation settings

    Hi,We&ve had a request from a customer asking if it would be possible in a later version to have the Write Off Small amounts wizard obey Transaction Date validation settings. IE if a transaction which is to be written off has a date in a close...
    Stuart Mcalister over 5 years ago in Write Off Small Amounts 0 Idea Accepted - Gauging Support

    Default Nominal Accounts. Allow quot;Use Specifiedquot; for any default

    Allow the option of nbsp;quot;Use Specifiedquot; for any of the default nominal codes, particularly in the Pamp;L section. This would allow Exchange Differences for examplenbsp;to be posted to an account with a Cost Centre / Dept but not the one s...
    Guest almost 11 years ago in Default Nominal Accounts 0 Idea Accepted - Gauging Support

    default nominal code for exchange differences

    For foreign currency customer accounts when you allocate a receipt to an invoice the automatic posting for exchange differences always adopts the default cost centre and department on the customer account. Potentially this means you have to set up...
    Jamie Davies almost 6 years ago in Default Nominal Accounts 0 Idea Accepted - Gauging Support

    Additional Control Ledger Nominal Accounts for Sales/Purchase Ledger.

    Addition to default Debtor / Creditor control Nominal Account, some customers have asked to allow them to assign a separate NL Control Account at Supplier / Customer account level. By default Customer/Purchase Account will have default debtor/cred...
    Rustum Khedkar almost 9 years ago in Default Nominal Accounts 4 Idea Accepted - Gauging Support

    Default Nominal Accounts - Ignore Cost Centre and Departments

    [ASM-System-System Settings] allows you to set &Split postings between cost centres for Balance Sheet accounts& And then further controlled in [Nominal-Utilities-Ledger Setup-Default Nominal Accounts] for Creditors& and Debtors& Co...
    Guest about 7 years ago in Default Nominal Accounts 0 Idea Accepted - Gauging Support

    Being able to change the default Write Off Value in Write off Customer Small Amounts

    The default value inWrite off Customer Small Amounts is the extremely large figure of £200, there seems to be nowhere you can change this. Given that this is normally used to write off a few pence here and there, £200 seems an awful lot. Ive check...
    Guest over 2 years ago in Write Off Small Amounts / Write Off Small Amounts 0 Idea Accepted - Gauging Support

    Deferred Transaction List

    I had a journal stuck in the deferred transaction list as the account code did not exist i.e. cost centre and department code did not exist in the combination used. I set-up the account code and then went to correct the journal in the list, but it...
    Guest over 2 years ago in Default Nominal Accounts 0 Idea Accepted - Gauging Support