Allow separate default nominal codes for Bad Debt and Bad Debt Provision
At the moment the system only has on nominal code for writing off the bad debt or bad debt provision.
It would be better if there were separate default nominal codes for these.
P&L report which allows you to compare current Quarter with Prior Year Quarter
P&L MTD report which allows you to compare current Quarter with Prior Year Quarter thus allowing for seasonal fluctuations in business ideally compare any group of months with the same Months in the Prior year or multiple years or compare a gr...
Victoria Hanley
about 8 years ago
in Profit and Loss
0
Idea Accepted - Gauging Support
Improvements to the Nominal Ledger Year End Report (Accumulated Profit/Loss)
The Nominal Ledger Year End Report shows a New Year ‘Credit’ figure against the ‘Accumulated Fund’ account, which does not include the new one-sided journal entry relating to the sum of all the P&L Account balances (which have just been cleare...
Eric Belshaw
about 4 years ago
in Profit and Loss
0
Idea Accepted - Gauging Support
Profit & Loss report to tell you if a nominal or report category is missing like Sage 50
Please can there be an optional message or notification added to a P&L when run to advise if a report category or nominal is missing from the report which could cause an imbalance? Sage 50 has this feature and we have a few customers who have ...
Default Nominal Accounts. Allow quot;Use Specifiedquot; for any default
Allow the option of nbsp;quot;Use Specifiedquot; for any of the default nominal codes, particularly in the Pamp;L section. This would allow Exchange Differences for examplenbsp;to be posted to an account with a Cost Centre / Dept but not the one s...
For foreign currency customer accounts when you allocate a receipt to an invoice the automatic posting for exchange differences always adopts the default cost centre and department on the customer account. Potentially this means you have to set up...
Additional Control Ledger Nominal Accounts for Sales/Purchase Ledger.
Addition to default Debtor / Creditor control Nominal Account, some customers have asked to allow them to assign a separate NL Control Account at Supplier / Customer account level. By default Customer/Purchase Account will have default debtor/cred...
We have a number of P&L reports, by Cc, by dept/customer etc, the option to have the GP% overhead% and Net profit % on the reports would be very beneficial, also the ability to add this through the report designer would be a great addition,
Guest
almost 7 years ago
in Profit and Loss
0
Idea Accepted - Gauging Support
Profit and Loss report to show Gross Margin % and Net Margin %
Profit and Loss report to show Gross Margin % and Net Margin % Gross Margin % = Total Sales - Cost of Sales / Total Sales Net Margin % = Total Sales - Cost of Sales - Overheads / Total Sales
Guest
over 9 years ago
in Profit and Loss
0
Idea Accepted - Gauging Support
Default Nominal Accounts - Ignore Cost Centre and Departments
[ASM-System-System Settings] allows you to set &Split postings between cost centres for Balance Sheet accounts& And then further controlled in [Nominal-Utilities-Ledger Setup-Default Nominal Accounts] for Creditors& and Debtors& Co...
